If your van's livery is peeling, fading or just not winning you work any more, a professional wrap fitted at your Cambourne premises can turn that around fast.
Van wrapping means applying a shaped, printed vinyl film directly onto the bodywork of your vehicle. The film covers panels, bumpers, mirrors and door edges, leaving your original paintwork untouched underneath. When the wrap is eventually removed, the paint beneath is in the same condition as the day the wrap went on, which matters when you come to sell or re-register the van.
We design and print everything in-house, which means your artwork, colours and contact details are produced to an exact specification rather than being sent off to a third party and returned with surprises. Once the print is ready, we come to you. The fitting is done at your location in Cambourne, so your van stays local and you do not lose it to a workshop for days.
Most vans do not go from perfectly branded to embarrassing overnight. The decline is gradual, which is exactly why it goes unnoticed until a customer comments or you park next to a competitor's vehicle and see the difference plainly.
These are the signs that something needs doing:
Understanding what causes wrap deterioration helps you ask the right questions when you are choosing who to use and what film to specify.
Poor surface preparation. The single most common cause of premature lifting and bubbling is contamination on the paint surface at the time of fitting. Grease, wax residue, silicone polish and even fingerprints all prevent the adhesive bonding properly. A proper installation starts with a thorough chemical clean of every panel before the film goes near the van.
Low-grade film. Not all vinyl film is the same. Cast film is manufactured differently from calendered film: cast film is thinner, more conformable and holds its shape around curves and recesses without the memory that causes lifting at edges. Calendered film costs less but can shrink back over time, particularly around door pillars and wheel arches. We only use cast-grade film for full wraps.
Inexperienced fitting. Stretching film too aggressively over complex curves puts it under tension. When that tension relaxes in warm weather, edges pull away. Experienced fitters work at the right ambient temperature, use proper heating tools to relax the film into recesses, and avoid overstretching at any point.
No heat treatment at edges. Edges that are simply pressed down without being heated and sealed are far more likely to lift. The correct technique uses post-heat to lock the film's shape so it does not try to return to its flat state.
Incompatible paint surface. If a van has had a respray at some point, particularly a cheap one, the paint may not have the adhesion properties needed for a wrap. Fresh paint also needs time to cure fully before film is applied. These are things to check before the job starts, not discover after.
Ask what grade of film is being used and whether it is cast or calendered. Ask how the panels are prepared before the film goes on. If you are getting a full wrap, ask whether edge sealing and post-heat are part of the process. These are not unusual questions and any experienced wrapper should be able to answer them without hesitation.
Also ask where the work is done. Some operations require you to take the van to a fixed workshop. We fit at your premises in Cambourne, so your vehicle does not leave the area and you can carry on with your day while the job is done.
We also carry out wrap removal. If you are rebranding, selling a vehicle or simply updating an old design, the existing wrap can be removed cleanly without damaging the paintwork, provided it was applied correctly in the first place and the paint underneath is in reasonable condition. We handle this as a standalone job or as part of a full rebrand where we remove, redesign and refit in one process.
A full wrap on a standard medium wheelbase van typically runs from around £1,500 to £2,500 depending on the complexity of the design, the number of panels and whether any areas need specialist attention such as deep recesses or high-cut roof sections. Partial wraps, covering just the rear doors or side panels, cost less and can still deliver a strong visual. Spot graphics and cut vinyl lettering sit at the lower end of the range.
The investment needs to be weighed against what you spend on other advertising. A wrapped van is seen by a great many people every working day. Unlike a directory listing or a social media post, it does not need renewing monthly.
Call us to talk through what you need. We can discuss your existing artwork or start from scratch if you do not have anything yet. We come to you, and the design and print are handled in-house from the start.
Also available
We wrap commercial vehicles of all types in Cambridge, designing and printing everything in-house and fitting at your site.
See detailsWe brand entire fleets of commercial vehicles in Cambridge with consistent, professionally printed graphics, designing and fitting everything…
See detailsA full van wrap transforms your entire vehicle into a moving advertisement for your business.
See detailsLet us know what needs branding and we will send a design and price to look over.