Good minibus graphics in Trumpington should stay sharp for years - but only if they are looked after correctly from the day they go on.
Minibus graphics are applied directly to the vehicle's painted panels using pressure-sensitive vinyl film. The options range from simple cut-vinyl lettering - a name, phone number and logo - through to part wraps covering specific panels, and full wraps that cover every painted surface. Schools, care providers, sports clubs, shuttle operators and private hire businesses all use these differently, and the right level depends on your budget and what the vehicle needs to communicate.
Van Wrapping Cambridge designs and prints everything in-house and comes to customers in Trumpington to carry out the work at your site. The vehicle stays where it is kept - there is no need to bring it anywhere.
The most common reason minibus graphics fail before their time is not poor materials or bad application - it is what happens to the vehicle in the weeks and months after fitting. Harsh washing, chemical products not suited to vinyl, and ignored edge lifts are the three things that shorten the lifespan of graphics faster than anything else.
Exterior cast vinyl used for vehicle graphics is designed to last five to seven years or more under normal conditions. Calendered vinyl, which is used for shorter-term applications, typically performs well for three to four years. Neither material will reach its potential lifespan if the vehicle is put through an automatic brush wash every week or cleaned with solvent-based products.
Hand washing is always the best approach. Use warm water, a mild non-abrasive detergent and a soft cloth or sponge. Work from the top of the vehicle down, rinse thoroughly and dry with a clean chamois or microfibre cloth. The process is no different from washing the paintwork itself - gentle and consistent.
Automatic car washes with rotating brushes are the single biggest cause of edge lifting on vinyl graphics. The brushes catch exposed edges - particularly around panels, door frames and windows - and begin to peel the vinyl back from the edges inward. Once an edge starts to lift, moisture gets underneath and the problem spreads quickly.
Touchless automatic washes (high-pressure water jets only, no brushes) are safer but still not ideal. The pressure can force water under any edge that is not perfectly adhered. If you must use one, avoid directing the jet directly at panel edges or at an angle that gets underneath the vinyl.
Pressure washers used by hand carry the same risk. Keep the nozzle at least 30 centimetres from the surface, use a wide-angle setting and never direct the jet at an angle toward the edge of a graphic. Straight on, from a reasonable distance, is acceptable.
If you use specialist vinyl-safe cleaning products, follow the product instructions. For most day-to-day cleaning, mild washing-up liquid diluted in water is both effective and safe.
You can apply a liquid wax or sealant to vehicle graphics, but the product must be suitable for use on vinyl. Some standard car waxes contain petroleum distillates that degrade the film over time. If in doubt, check with the contractor who fitted the graphics before applying anything to the surface.
A suitable wax or sealant applied two or three times a year will help protect the surface from UV exposure and make the vehicle easier to clean between washes. It also reduces the chance of bird droppings and tree sap bonding strongly to the surface - both of which should be removed as soon as possible, as the acids in them will etch the film if left.
Run a visual check around all the panel edges every few months - around doors, wheel arches, windows and any areas where the vinyl wraps around a sharp corner. These are the places most likely to show the first signs of lifting. Early-stage edge lifts, where the vinyl has just started to peel back a few millimetres, can often be re-adhered without replacing the whole section.
Do not attempt to press a lifted edge back down with your fingers if it has been up for a while and has collected dust or moisture underneath. The contamination will prevent proper re-adhesion. The edge needs to be cleaned and, in most cases, a small amount of heat applied to reactivate the adhesive before pressing back down. This is a quick job for a fitter but a messy one to attempt without the right tools.
If a section has lifted significantly and the edge has curled, do not try to trim it or fold it back. Call the contractor and have it assessed. A small repair done promptly is far cheaper than replacing a whole panel because the lift was left too long.
Extended parking in direct sunlight accelerates fading, particularly on darker colours. Where you have a choice, parking under cover or in shade will extend the life of the graphics noticeably. This applies especially to full wraps on vehicles that sit unused for long periods.
Frost does not damage well-applied vinyl directly, but do not use an ice scraper on a graphic. Clear ice from windows carefully and avoid letting the scraper blade contact the vinyl surface on the bodywork.
When the time comes to rebrand or replace the graphics, we also offer full wrap removal as a service. Removal done properly should not damage the underlying paintwork, but the paint condition underneath depends on the vehicle's history and the age of the graphics. We will assess the vehicle before removal and give you an honest view of what to expect.
Keeping the vehicle in good condition in the meantime - particularly avoiding rust or paint damage at the edges of the graphic - makes removal cleaner when the time comes.
Van Wrapping Cambridge covers Trumpington and the surrounding area. We design, print and fit at your location, and can advise you on aftercare specific to your vehicle and how it is used. Call us to discuss your project and what to expect from the graphics over time.
Also available
We design, print and fit full or partial van wraps in Cambridge, working at your premises so your vehicle never leaves your site.
See detailsWe wrap commercial vehicles of all types in Cambridge, designing and printing everything in-house and fitting at your site.
See detailsWe brand entire fleets of commercial vehicles in Cambridge with consistent, professionally printed graphics, designing and fitting everything…
See detailsLet us know what needs branding and we will send a design and price to look over.