If the livery on your Haverhill business vehicles is fading, peeling or just inconsistent across your fleet, it is time to look at what is causing the problem and what a proper fleet wrap can do about it.
A branded vehicle that looks tired or patchy does the opposite of what you intended. Potential customers notice a peeling decal or a colour that has bleached out from the original. For businesses running multiple vehicles in and around Haverhill, inconsistent livery is one of the most common and most avoidable problems we see discussed by fleet managers and business owners.
The signs are usually gradual. One van gets a new half-wrap while the others keep the old design. A vehicle comes back from a bodyshop respray and the colours no longer match. Graphics applied years apart look like they belong to different companies. By the time it is obvious to you, it is obvious to everyone else too.
These are the things worth checking before you decide what to do next:
Poor surface preparation is the single biggest cause of premature wrap failure. If a vehicle panel has wax, silicone, grease, dust or any contaminant on it when the film goes down, adhesion is compromised from day one. A proper installation starts with a thorough clean, often a panel wipe with a specialist cleaner, before any film is touched.
Film quality matters too. There is a wide range of cast and calendered vinyl films on the market. Cast film is made in a different way to calendered film, and it conforms better to compound curves, door handles and recesses. Cheaper calendered films are stiffer and more likely to lift at edges and around body detail. For a commercial vehicle that works hard every day, the choice of film makes a real difference to how long the graphics hold up.
Application temperature is another factor that is easy to overlook. Vinyl film applied in cold conditions becomes less pliable, which makes it harder to work around curves and increases the chance of stress in the film once temperatures change. A good installer works in a controlled environment or adjusts technique for the conditions.
Age is simply unavoidable. Even well-applied, quality graphics have a natural lifespan. After several years of daily use, washing and exposure to the elements, any wrap will start to show wear. The question is whether it deteriorates gradually and predictably, or prematurely because of an avoidable issue at the installation stage.
Consistent fleet livery means every vehicle carries the same colours, the same logo placement, the same font and the same general layout, regardless of vehicle size or shape. That sounds straightforward, but it requires proper artwork set up for each vehicle template, accurate colour matching across print runs, and a process for phasing in new vehicles without the fleet looking disjointed while work is underway.
We design and print in-house at Van Wrapping Cambridge, which means the same colour profiles are used for every vehicle in your fleet. There is no handoff between a designer and a separate print supplier, so the colours you approve on the first van are the colours that come out on the fifth. We also travel to your premises in Haverhill to carry out the installation, so your vehicles stay close to your base and you do not need to arrange transport to a workshop.
Phased installation is worth planning carefully. If you run six vans and cannot take them all off the road at once, we can work through the fleet in batches. The first vehicles to be wrapped set the standard, and every subsequent vehicle is matched to them. This is far more reliable than using different suppliers over time and hoping the colours come out the same.
If your current livery is reaching the end of its life, or your business has rebranded and you need to start fresh, wrap removal is the right first step. Done carefully, removal leaves the original paintwork in good condition. Done badly - with heat guns set too high, or by pulling film at the wrong angle - it can damage paint or leave adhesive that is very difficult to shift.
We carry out wrap removal as part of our service. For a Haverhill fleet manager planning a rebrand, it makes sense to remove old graphics and apply new ones as a managed process rather than applying new film over degraded existing graphics. Layering old and new film causes problems with edge thickness, adhesion and overall finish.
Before agreeing to any fleet wrapping work, it is worth asking these questions:
If you are running a fleet in Haverhill and want to talk through what is going wrong with your current livery, or how to plan a rebrand properly, call us and we will give you a straight answer.
Also available
We design, print and fit full or partial van wraps in Cambridge, working at your premises so your vehicle never leaves your site.
See detailsWe wrap commercial vehicles of all types in Cambridge, designing and printing everything in-house and fitting at your site.
See detailsA full van wrap transforms your entire vehicle into a moving advertisement for your business.
See detailsLet us know what needs branding and we will send a design and price to look over.